Table of contents: External rear light installation… ↓ Removal and installation the lamp… ↓ Replacing the rear side marker light… ↓ Inner rear light ↓ Removal and installation the rear… ↓ Removal and installation the rear… ↓
External rear light installation diagram
1. Rear light bulb. running: left rear light lamp. "M16" travel, right rear light bulb. "M17" move; 12 V, 16 W; W16W.
2. Rear turn signal lamp: rear turn signal lamp. left turn signal "M6", rear lamp. right turn signal "M8"; 12V 21W: orange.
3. Lamp holder.
4. Nut: 3.5 Nm.
5. Threaded pin: 3.5 Nm.
6. External rear lights.
Removal and installation the lamp holder
Remove the outer rear parking light. Unscrew the "arrow" nuts. Remove the bulb socket "2" from the rear light assembly "1". Unscrew the bulbs from the socket. Unscrew the turn signal lamp "3". Remove lamp "4" from the rear light. move.
Installation in reverse order. Insert the new lamp into the socket, being careful not to touch the glass bulb of the lamp with your bare hands. Secure the lamp holder by turning it clockwise. Install the rear. external clearance light.
Replacing the rear side marker light bulb "M37"/"M38"
The rear side marker light bulb is an LED and is installed in the outer part of the rear. block of lights. Replacing LEDs is not possible, the outer part of the rear. the headlight assembly must be replaced completely.
Inner rear light
1. Inner rear light.
2. Rear fog light bulb: left rear fog light bulb. fog light "L46", right rear lamp. fog light "L47"; 12 V, 21 W.
3. Lamp holder.
4. Nut: 3.5 Nm.
5. Clamp bracket: for mounting the rear light. lighting to the trunk door.
Removal and installation the rear interior marker light
Turn off the ignition. Set the light switch to position 0. Remove cover "1" from the outside of the driver, "arrow".
Disconnect plug connection "2". Unscrew nut "3" and remove clamp bracket "4". Slightly move the inner part of the rear. the light unit outwards "arrow A" and remove "in the direction of arrow B" from the trunk.
Installation
Installation in reverse order. Ensure that the gasket between the body and the rear housing is installed correctly. light. Install the inner section of the rear. lamp on the outer edge of the trunk door. Slide the clamping bracket "2" onto the threaded pin of the inner part of the rear. block of lights. The guide pin "4" of the rear light must enter the fastening "3" of the clamp bracket. Tighten nut "1". When tightening the nuts, the clamp bracket is wedged backwards. "arrow" cover.
Removal and installation the rear fog light bulb "L46"/"L47"
Turn off the ignition. Set the light switch to position 0. Remove cover "1" from the outside of the driver, "arrow". Disconnect plug connection "1". Remove socket "3" from the housing by loosening the retaining clips "2". Unscrew bulb "4" of the rear fog light from the socket.
Installation in reverse order. Insert the new lamp into the socket, being careful not to touch the glass bulb of the lamp with your bare hands.