Table of contents: Rear light assembly, outer part ↓ Removal and installation the lamp… ↓ Replacing the rear side marker light… ↓ Inner rear light ↓ Removal and installation the lamp… ↓
Rear light assembly, outer part
1. Outer rear lights: LED replacement is not possible, outer part of the rear. the headlight assembly must be replaced completely.
2. Turn signal lamp: rear lamp. left turn signal "M6", rear lamp. right turn signal "M8"; 12 V, 21 W.
3. Lamp; 12 V, 21 W.
4. Bolt: 1.7 Nm.
5. Lamp holder.
6. Threaded pin: 3.5 Nm.
Dismantling
Turn off the ignition. Set the light switch to position 0. Open the trunk side trim cover. Unscrew the threaded pin "2". Tilt the rear. block of lights "1" outward "arrow" and at the same time remove the lock bolt from the body. Disconnect the plug connection.
Installation
Installation in reverse order. Self-adhesive seal on the rear body. the clearance light should seal well. Install the rear. the light assembly on the body and press the locking bolt into the hole. Tighten the pin with thread "2".
Removal and installation the lamp holder
Remove the outer rear parking light. Unscrew the "arrow" bolts. Remove the lamp socket "1" from the rear light assembly. Unscrew the lamps from the sockets.
Installation in reverse order. Insert the new lamp into the socket, being careful not to touch the glass bulb of the lamp with your bare hands. Install the rear. external clearance light.
Replacing the rear side marker light bulb "M37"/"M38"
The rear side marker light bulb is an LED and is installed in the outer part of the rear. block of lights. Replacing LEDs is not possible, the outer part of the rear. the headlight assembly must be replaced completely.
Inner rear light
1. Inner rear light.
2. Rear light bulb. running: left rear light lamp. "M16" travel, right rear light bulb. stroke "M17": 12 V, 16 W (W16W).
3. Tail light bulb: left rear light bulb. side light "M4", right rear lamp. side light "M2"; 12 V, 21 W.
4. Lamp holder.
5. Seal: Replace if damaged.
6. Rear lamp. lamp and fog lamp: left side light and rear lamp. fog lamp "M41", right side light and rear lamp. fog lamp "M42"; 12 V, 21 W.
7. Nut: 3.5 Nm.
8. Clamp bracket: for mounting the rear light. lighting to the trunk door.
Dismantling
Turn off the ignition. Set the light switch to position 0. Pry off cover "1" with wedge "3409" "arrow".
Disconnect plug connection "2". Unscrew nut "3" and remove clamp bracket "4". Slightly move the inner part of the rear. the light unit outwards "arrow A" and remove "in the direction of arrow B" from the trunk.
Installation
Installation in reverse order. Ensure that the gasket between the body and the rear housing is installed correctly. light. Install the inner section of the rear. lamp on the outer edge of the trunk door. Slide the clamping bracket "1" onto the threaded pin of the inner part of the rear. block of lights. Tighten nut "2". When tightening the nuts, the clamp bracket is wedged backwards. "arrow" cover.
Removal and installation the lamp holder
Turn off the ignition. Set the light switch to position 0. Pry off cover "1" with wedge "3409" "arrow".
Remove the lamp holder "1" from the housing by pressing the locking clip "2" in the direction of the arrow. Unscrew the rear lamp. side light or rear. fog lamp from the socket. Remove the rear light bulb. stroke from the cartridge.
Installation in reverse order. Insert the new lamp into the socket, being careful not to touch the glass bulb of the lamp with your bare hands.
(The original text is available on the website: «AUDImanual»)