Table of contents: External rear light installation… ↓ Removal and installation of rear.… ↓ Removal and installation the lamp… ↓ Inner rear light ↓ Removal and installation the rear… ↓ Removal and installation the rear… ↓
External rear light installation diagram
1. External rear lights.
2. Rear turn signal lamp: rear turn signal lamp. left turn signal "M6", rear lamp. right turn signal "M8"; 12 V, 18 W; W16W.
3. Sealing ring.
4. Central socket of the lamp base.
5. Threaded pin: 3.5 Nm.
Removal and installation of rear. side light
Turn off the ignition. Set the light switch to position 0. Open the trunk side trim cover. Unscrew the threaded pin "2". Tilt the rear. side light "1" outward "arrow", while removing the fasteners from the body. Disconnect the plug connection.
Installation
Installation in reverse order. Self-adhesive seal on the rear body. the clearance light should seal well. Install the rear. the side light onto the body and insert the clips into the holes. Tighten the threaded pin.
Removal and installation the lamp holder
Remove the outer rear parking light. Turn lamp holder "1" counterclockwise "arrow" and remove it from the housing. Remove the lamp from the socket. "Pos. 2" should not be taken into account.
Installation in reverse order. Insert the new lamp into the socket, being careful not to touch the glass bulb of the lamp with your bare hands. Secure the lamp holder by turning it clockwise. Install the rear. external clearance light.
Inner rear light
1. Inner rear light.
2. Seal: Replace if damaged.
3. Rear fog light bulb: left rear fog light bulb. fog light "L46", right rear lamp. fog light "L47"; 12B, 21W.
4. Sealing ring.
5. Large clamp bracket: for mounting the rear light. lighting to the trunk door.
6/8. Nut: 3.5 Nm.
7. Central plug of lamp sockets.
9. Small clamp: for mounting the rear light. lighting to the trunk door.
10. Sealing ring.
11. Rear light bulb. running: left rear light lamp. "M16" travel, right rear light bulb. "M17" move; 12 V, 18 W; W16W.
Removal and installation the rear interior marker light
Turn off the ignition. Set the light switch to position 0. Pry off cover "1" with wedge "3409" "arrow". Disconnect plug connection "5". Unscrew nut "2" and remove large clamp bracket "1". Unscrew nut "4" and remove small clamp bracket "3". Remove inner section of rear. lantern to the outside.
Installation
Installation in reverse order. Ensure that the gasket between the body and the rear housing is installed correctly. light. Install the inner section of the rear. lamp on the outer edge of the trunk door. Slide the small clamp "3" onto the threaded pin of the inner section of the rear. lantern and screw on nut "4" without tightening it. Slide the large clamp "1" onto the threaded pin of the inner section of the rear. lantern and tighten nuts "2" and "4". When tightening the nuts, the clamping brackets are wedged towards the rear. "arrow" cover.
Removal and installation the rear fog light bulb "L46"/"L47"
Turn off the ignition. Set the light switch to position 0. Pry off cover "1" with wedge "3409" "arrow". Turn base "1" counterclockwise "arrow" and remove from the rear housing. lamp. Unscrew the rear lamp. fog lamp from the base.
Installation in reverse order: insert the new lamp into the socket, being careful not to touch the glass bulb of the lamp with bare hands.