Table of contents: External rear light installation… ↓ Removal and installation the rear… ↓ Inner rear light ↓ Removal and installation the rear… ↓
External rear light installation diagram
1. External rear lights.
2. Rear light bulb. running: left rear light bulb. "M16" travel. Right rear light lamp. "M17" move; 12 V, 18 W; W16W.
3. Lamp holder.
4. Threaded pin: 3.5 Nm.
Removal and installation the rear light bulb. stroke "M16"/"M17"
Remove the outer rear parking light. Turn lamp holder "1" counterclockwise "arrow" and remove it from the housing. Remove the reversing light bulb from the socket.
Installation in reverse order. Insert the new lamp into the socket, being careful not to touch the glass bulb of the lamp with your bare hands. Install the rear. external clearance light.
Inner rear light
1. Inner rear light.
2. Seal: Replace if damaged.
3-5. Nut.
Tightening torque and sequence for inner rear light
Tighten the nuts in sequence. "1, 2, 3" with a torque of 4 Nm.
Removal and installation the rear interior marker light
Turn off the ignition. Set the light switch to position 0. Pry up cover "1" with wedge "3409" "arrow". - Disconnect plug connection "1". Unscrew the nut "arrow". Remove the inner section of the rear. lantern to the outside.
Installation in reverse order. If the LED is faulty, the rear one should be replaced. interior marker light assembly. Ensure that the gasket between the body and the rear housing is installed correctly. lantern.