16.1a. Temperature sensor in the left air duct of the instrument panel
16.1b. Temperature sensor in the right air duct of the instrument panel
2. To remove the temperature sensor in the right or left air duct to the foot well, remove the climate control unit (see Section 9) and through the resulting hole, disconnect the connector (And in the illustrations) sensor, turn it at an angle of 90° and pull it out of the climate control system housing.
16.2a. Temperature sensor in the air duct of the left foot well
16.2b. Temperature sensor in the air duct of the right footwell
3. To remove the solar sensor, gently press the cover (And in the illustration) from the windshield deflector in the direction of the arrow. Pull out the sensor (B) and secure the connector (C) so that it does not slip down.
16.3. Solar radiation sensor installation details
Note: On some models the sensor is additionally secured with a screw.
4. To remove the outside air quality sensor, remove the windshield fairing (see Section 15 Chapter 1), disconnect the connector (1 in the illustration), press the lock (B) and pull the sensor (C) downwards.
16.4. Outdoor air quality sensor
Note: In the connector, pin 1 is "terminal 15", pin 2 is "terminal 31", and pin 3 is the signal wire.
5. To remove the window defroster flap actuator, remove the glove compartment (see Chapter 11), disconnect the connector (And in the illustration), remove the bolts (B), separate the activator from the support (C), and then separate the activator lever (D) from the connecting rod (E).
16.5. Installation details of the windshield blower flap actuator
6. To remove the right or left temperature flap, first remove the glove compartment on the passenger or driver side, respectively (see Chapter 11). Then disconnect the connector (And in the illustrations), unscrew the bolts (B) and separate the activator lever (C) from the connecting hose (D).
16.6a. Right temperature flap actuator installation details
16.6b. Left Temperature Flap Actuator Installation Details
7. To remove the central flap actuator, remove the glove compartment (see Chapter 11), disconnect the connector (And in the illustration), unscrew the bolts (B) and separate the activator.
16.7. Details of installation of the left central flap actuator
8. To remove the fresh air flap actuator, remove the glove compartment (see Chapter 11), disconnect the connector (And in the illustration), unscrew the bolts (B) and separate the connecting element (C) of the activator from the shaft (D) of the damper.
16.8. Fresh air flap actuator installation details
(This article was copied from the website «AUDIMANUAL.ru»)