Table of contents: Removal ↓ Installation ↓
Removal
1. Remove the rear door entry strip, refer to the relevant Section.
2. Remove the top trim of the B-pillar, refer to Section Removal and installation the upper trim of the B-pillar.
3. Disconnect the trim (1) at the bottom using the spring clips (2), move it upwards and pull it out of the belt guide (4).
Installation
1. Installation is performed in the reverse order of removal. In this case, the guide pin (5) must enter the hole in the door threshold.
Warning: Make sure the seat belt (3) is routed correctly.
2. Place the door seal over the trim.
[This publication is borrowed from the resource: audimanual]