Table of contents: Removal ↓ Installation ↓
Replacement is necessary when the quality of glass cleaning deteriorates. In this case, only the rubber bands can be replaced, or together with the brush holders. If only the rubber bands are replaced, it is necessary to check whether the brush holder has any deformations.
Removal
1. Lift the lever and hold the brush perpendicular to the lever.
2. Press the spring clip in the direction of the arrow and slide the brush down from the hook on the lever. Remove the brush from the hook on the lever.
3. Using pliers, squeeze both steel tires on the closed side of the brush and pull them out of the upper bracket from the side. Then pull the rubber together with the guides out of the remaining part of the brush bracket.
Installation
1. Insert the new rubber band without tires into the lower brackets of the brush.
2. Insert both tires into the first groove of the brush so that the grooves of the tires point towards the rubber and fix them in the groove tabs.
3. Press both steel bars and the brush together with pliers and insert into the upper bracket so that the bracket tabs on both sides enter the grooves (arrow on the accompanying illustration) brushes.
4. Insert the brush (2) into the lever (1). The brush of the left lever should connect with the clamp, and the guide tab should enter the brush.
5. Press the lock button and secure the brush.
6. Fold the brush back. Make sure that the rubber band of the brush is in contact with the glass along its entire length; if necessary, carefully bend the holder.