Table of contents: Installation ↓ Examination ↓
1. Remove the sliding panel covers, refer to Section Removal and installation the sliding roof panel trim.
2. Remove the screws on both sides.
3. Remove the panel upwards.
Installation
1. Replace the sliding panel and secure it with screws.
2. Install the covers.
Examination
1. To prevent noise from occurring due to wind, the sliding panel must be installed at a height in accordance with the specified dimensions.
Warning: When doing this, close the sliding panel from its rear position, not from the top position.
2. Check the height adjustment at the edge of the roof cutout radius in relation to the center of the car. The panel should not be higher in the front and lower in the back than the roof itself.