Safety rules for bodywork (Audi A4 B6)

Seat belt tensioner: If the vehicle is equipped with seat belt tensioners that instantly tighten the belts in the event of a collision, special precautions must be taken during bodywork. These devices are activated by gas generators with electrical ignition. Independent repair of the seat belt tensioner system is strictly prohibited. The removal and installation of these devices must be carried out by workshops that are required to comply with strict safety regulations. During bodywork, use an impact screwdriver or hammer near the automatic belt retractor mechanism with special care. Seat belt tensioners are sensitive to vibration and strong impacts, so they can be triggered. To be on the safe side, before any work, pull out the corresponding fuse at the bottom of the car and wait 5 minutes until the capacitors are discharged.

Galvanized: The outside of the body is galvanized using electrolytic galvanizing, and the inside is hot-dip galvanized. Welding produces toxic zinc oxide, so make sure there is sufficient ventilation in the workplace.

Air conditioner: Welding or soldering work that may heat up the air conditioner parts is prohibited. Opening the refrigerant circuit is prohibited.

Electrical equipment: When welding or other work is performed that may generate sparks, be sure to disconnect the battery and carefully insulate both battery terminals (+) and (-).

(The original version of the article is posted on the website: AUDImanual.ru)