Note: Removal and installation is the same as for the front bumper.
1 - guide piece
Press the ends of the bumper down -arrow C- and remove them from the guides outward.
2 - Phillips head screw
3 - nuts, 23 Nm
4 - lining washer
5 - gasket
6 - bracket
7 - spacer washer
8 - bumper
When removing, pull the end of the bumper away from the body. When installing, insert the bumper from below into the 4 latches.
Please note: with 9.88 the bumper is not secured on the side.
The gap between the bumper and the body on the side of the trunk for AUDI 80/Coupe: 9+1 mm along the entire length. AUDI 90 8+1 mm.
9 - spacer element
Only on the right side
10 - polymer nut
11 - rear part detail
12 - 4 fastening latches
Please note: If the self-adhesive seal of the rear right bumper is replaced, observe the dimensions, the distance to the rear mounting bolts of the guide element is 280 mm.