Removal and installation the rear bumper (Audi A2)

1. Guide profile
2. Bolt, 2 Nm
3. Self-tapping screw, 1.5 Nm
4. Profile of the amplifier. Before removing, dismantle the bumper cover. Completely unscrew the bolts and remove the profile
5. End nut. Inserted into the body
6. Self-tapping screw
7. Bracket, 1.5 Nm
8. Hexagon head bolt, 23 Nm
9. Combination bolt, 23 Nm
10. Crossbar. Before removing, remove the bumper cover. Loosen the hexagon-head bolts and remove the crossbar from the bracket
11. Trim. Lightly press the trim into the body edge and detach the trim from the clips. Detach the trim on the left and right and remove it
12. Self-tapping screw, 2 Nm
13. Cover. Remove the mudguard liner at the rear. Unscrew the bolts under the mudguard liner. And also the bolts at the bottom. Disconnect the trim from the bumper cover. Remove the cover from the side of the guide profile and remove the cover from the car in the rear direction. When installing, the guide profile clamps should snap into the cover
14. Self-tapping screw, 1.5 Nm