6.0. Drive shaft and CV joints:
1 - clamp for fastening the inner CV joint boot to the large diameter landing belt
2 - inner CV joint cover
3 - clamp for fastening the inner CV joint boot to the small diameter landing belt
4 - retaining ring. To be replaced after each dismantling
5 - outer CV joint. Replaced only as a complete unit. The outer diameter of the CV joint depends on the type of power unit and can be 100 mm or 108 mm
6 - hub bolt. To be replaced after each dismantling
7 - clamp for fastening the outer CV joint boot to the large diameter landing belt
8 - outer CV joint cover
9 - clamp for fastening the outer CV joint boot to the small diameter landing belt
10 - drive shaft
11 - retaining ring
12 - CV joint sprocket "Tripod". The chamfer of the spline hole should be facing the splines of the drive shaft (see arrow)
13 - retaining ring. To be replaced after each dismantling
14 - bolts for fastening the CV joint to the gearbox
15 - inner CV joint housing
6.0a. Rear wheel drive shaft:
1 - hub bolt M16. Tightening torque 190 Nm + 180° turn. To be replaced after each dismantling
2 - outer CV joint. Replaced as a set
3 - retaining ring. To be replaced after each dismantling
4 - thrust ring
5 - gasket
6 - retaining ring. To be replaced after each dismantling
7 - clamp for fastening the outer CV joint boot to the large diameter landing belt
9 - drive shaft
10 - inner CV joint cover. To be replaced after each dismantling
11 - sealing gasket
12 - inner CV joint. Replaced as a set
13 - balancing gasket
15 - M10 bolt with a head for a multi-sided socket wrench. Tightening torque 70 Nm
16 - inner CV joint cover