Table of contents: Removal and installation the control… ↓ Removal and installation the front… ↓ Removal and installation of rear.… ↓
Electrical system. adjustable, damping
1. Charisma "E592" switching module: installation location: Charisma "592" switching module is installed in the front panel.
2. System control unit. electric damping control "J250"; installation location: system control unit. electric damping control "J250" is located at the rear in the right side trim of the trunk; when replacing the system control unit. electrical damping control "J250" requires re-adapting the standard suspension position; if the control position is re-adapted on a vehicle with lane departure warning system, the lane departure warning system control unit "J759" must be recalibrated.
3. Shock absorber with rear adjustment valve. right shock absorber "N339".
4. Road sensor rear clearance. left "G76" and door sensor. rear clearance. right "G77"; when removing and installing the rear. left door sensor. clearance "G76" and rear right door sensor. clearance "G77" or removing the rods on a car with an electrical system. damping adjustment, the standard position of the suspension should be re-adapted; if the steering position is re-adapted on a vehicle with lane assist, the lane assist control unit "J759" must be recalibrated; for vehicles with automatic headlight range control, perform a basic headlight installation.
5. Vehicle acceleration sensor, rear. "G343".
6. Shock absorber with rear adjustment valve. left shock absorber "N338".
7. Front left vehicle acceleration sensor "G341" and front right vehicle acceleration sensor "G342".
8. Shock absorber with front left shock absorber adjustment valve "N336".
9. Front left ground clearance sensor "G78" and ground clearance sensor. front right clearance "G289"; when removing and installing the front left door sensor. clearance "G78" and front right door sensor. clearance "G289" or removing the rods on a vehicle with an electrical system. damping adjustment, the standard position of the suspension should be re-adapted; if the steering position is re-adapted on a vehicle with lane assist, the lane assist control unit "J759" must be recalibrated; for vehicles with automatic headlight range control, perform basic headlight installation.
10. Shock absorber with front right shock absorber adjustment valve "N337".
Removal and installation the control unit of the system. electric damping control "J250"
System control unit. electric damping control "J250" is located at the rear in the right side trim of the trunk. Turn off all electrical consumers. Remove the key from the ignition switch. Remove the right trunk compartment lid. Unlock and disconnect plug connector "3". Press clamp "2" to the side and remove the system control unit. electric damping control "J250" "1".
Installation
Installation in reverse order. Conduct a new adaptation of the system control unit. electric damping control "J250".
Removal and installation the front left "G341" and right "G342" acceleration sensor
Remove the wheel. Remove the front fender liner. Unlock and disconnect plug connector "2". Loosen nuts "1" and remove sensor "3".
Installation
Installation in reverse order. When installing, take into account the installation. sensor position. Install the sensor as shown in the figure. Tighten nuts "1" to 5 Nm.
Removal and installation of rear. vehicle acceleration sensor "G343"
Remove the wheel. Remove the rear left fender liner. Unlock and disconnect plug connector "2". Unscrew bolts "1" and remove sensor "3".
Installation
Installation in reverse order. When installing, take into account the installation. sensor position. Install the sensor as shown. Tighten bolts "1" to 5 Nm.
(A link to the original source is available on the website: AUDImanual.ru)