Withdrawal
Remove the 2 air filter cover screws.
Open the lock and remove the air filter cover.
Take out the filter element.
Unscrew the 3 fixing nuts of the filter housing. Make sure that the nuts do not fall into the carburetor.
Remove the air hose from the headlight cover.
Remove the crankcase breather hose from the cylinder head. If the hose is secured with a clamp, use HAZET 798-4 pliers.
Raise the lower part of the air filter, release the fuel line. Remove the vacuum hose with the black connection at the bottom of the air filter housing. To do this, insert a screwdriver between the retaining spring and the hose and press the spring slightly.
Take out the air filter housing
Installation
Attach the vacuum hose to the air temperature controller. Make sure that the mounting spring is firmly seated.
Install the air filter housing on the carburetor, at the same time put the heated air hose on the nozzle.
Attach crankcase breather hose to cylinder head. Secure with clamp.
If there is slight contamination, knock out the filter element with the palm of your hand. Replace oily or smoky filter.
Insert filter element.
Put on the cover so that the notch falls on the protrusion of the filter housing.
Close the clip and screw on the air filter cover.
Insert the air hose into the headlight cover.
Visitor comments