Table of contents: Removal ↓ Installation ↓
1 - swivel bracket
2 - screw, 3 Nm
3 - door handle
4 - overlay
5 - lock washer
6 - actuator lever with hinge bushing
7 - spring
8 - sealing ring
9 - lock cylinder
Remove only with key inserted.
Removal
Remove the inner door trim.
Remove screw "2".
Tilt the swivel bracket back 65°.
Pull the door handle inward.
If you need to remove the lock cylinder, pull the cylinder out with the escutcheon. Remove the rotary bracket. Remove the lock cylinder with the key inserted, slightly slanting the escutcheon.
Installation
Insert the cylinder with the lining. Ensure that the spring is positioned correctly. The ends of the spring "1" in the compressed state should lie respectively on the left and right on the front part of the actuator lever "2".
The actuator lever and cylinder should be pushed to the middle position under the action of the spring.
Insert the door handle so that its projection covers the lock cylinder. Snap the handle onto the escutcheon pin.
Screw in screw "2" without tightening too much.
Insert the pivot bracket, press and turn to position "A"; latch "1" of the pivot bracket should snap into the position of the pivot bracket in the open state.
Install the door trim.