Steering column 1. Bolt; 2. Support bracket; 3. Central pipe; 4. Bolt. 5 Nm; 5. Used ELV "J764". After replacing the ELV "J764" control unit, it is necessary to perform the following work using a tester. To do this, select the appropriate program in the "guided functions" and follow the instructions on the display; 6. Steering column. Depending on the steering design (with or without dynamic steering) different steering column options are installed, compliance. The "arrow" regulator is installed on a car with dynamic control. Do not unscrew or remove the "arrow" regulator from the steering column. The regulator and steering column are a single unit, replaced as a set. The "arrow" regulator has a "safety lock for the active steering system" (blocking magnet). When replacing the steering column with the adjuster, it is necessary to perform the basic adjustment of the dynamic steering system. Check for damage 7. Right energy absorbing bracket for footwell. Installed depending on the sales market; 8. Bolt. 20 Nm. 2 pcs. Depending on the sales market, the right energy-absorbing bracket for the driver's side footwell is also secured with this bolt. Observe the installation sequence when installing; 9. Bolt; 10/11/14. Bolt. 20 Nm. 2 pcs. Observe the installation sequence during installation; 12. Pen; 13. Bolt. 3 Nm; 15/18. Bolt. 30 Nm + 90° further. Replace each time it is removed. Always clean the threaded hole under the bolt (for example, with a tap); 16. Sealing sleeve. Align the positioning arrow to the "12 o'clock" position; 17. Intermediate steering shaft