Installation
Install in reverse order. In this case, the tightening torque must be taken into account. When replacing only the ELV control unit -J764-, the previously installed control unit mounting bolt must be used again. When replacing the steering column, the protective cover must be removed and the mounting bolt for the ELV control unit -J764- supplied with the new steering column must be used. When installing the ELV control unit, insert the pin -arrow A- into the groove -arrow B- in the steering column.
After connecting the plug connector -2-, make sure that the wiring harness -3- is secured using the clamp -5- in the designated place.
Make sure that the wiring harness -3- of the ELV control unit -J764- -1- is not pinched or touched by sharp edges when moving the steering column. After replacing the ELV control unit -J764-, further work must be carried out using. To do this, select the appropriate program in "slave functions" and follow the instructions on the display. If the steering wheel angle sensor warning lamp -G85- in the instrument cluster comes on after replacement, the fault must be repaired in mode "Guided troubleshooting" using the Diagnostic complex -VAS 5051 B-. If necessary, recalibrate the system.
Visitor comments