1.0v. Clutch Components:
1 - expansion tank with brake fluid
2 - supply hose
3 - pipeline
4 - pedal bracket
5 - clutch pedal
6 - bolts of fastening of the main brake cylinder with a head under a hex socket wrench. Tightening torque 20 Nm
7 - connecting finger of the clutch pedal and the main brake cylinder
8 - clutch master cylinder
9 - sealing gasket. Cannot be dismantled
10 - clamp
11 - gearbox
12 - working cylinder. Made of plastic
13 - bleed valve. Tightening torque 5 Nm
14 - bleeder cap
15 - pipeline clamp
16 - pipeline bracket
17 - a bolt with a head under a hex socket key of fastening of an arm to the working cylinder. Tightening torque 20 Nm
18 - pipeline holder nut. Tightening torque 2 Nm
19 - gasket
Attention! After removing the slave cylinder, do not depress the clutch pedal. When installing a working cylinder with a plastic support ring, the outer surface of the ring should be lubricated with a thin layer of grease. When installing, the cylinder should be pressed out with a pry bar so that the mounting bolt can be screwed in.
Attention! Brake fluid must not be allowed to enter the surface of the gearbox housing. Any spilled liquid should be removed immediately with a rag.
1.0g Hydraulic clutch with PTL valve
Visitor comments