1.0a. Clutch release details:
1 - gearbox
2 - spacer
3 - input shaft seal. Press-in depth for repair 4.5 mm
4 - guide sleeve
5 - guide bush mounting bolt (3 pcs,). Tightening torque 15 Nm
6 - clutch release fork
7 - spring washer
8 - washer mounting bolt. Tightening torque 25 Nm. The bolt must be replaced after each dismantling
9 - clutch release bearing. The bearing should only be wiped, not washed. If the bearing «making noise», then it should be replaced with a new one
10 - clutch slave cylinder 11 - bolt. Tightening torque 23 Nm
12 - clutch pipeline holder. Attached to the working cylinder
13 - pusher (plunger). The pusher end should be lubricated with copper grease, for example, AUDI/VW381351 TE
Visitor comments