Table of contents: Removal ↓ Installation ↓
Activated Carbon Absorber System Parts and Assemblies 1. Ventilation hose to the el. magnetic valve 1 of the absorber with activated carbon "N80". To disconnect, press the fitting lock. Fixed under the bottom on brackets; 2. Sealing ring; 3. Valve; 4. Ventilation hose from the fuel tank. To disconnect, press the fitting lock; 5. Ventilation pipe. Exits under the rear left fender liner; 6. Absorber with activated carbon. Installation location: on the bottom of the car under the trim at the back, on the left; 7. Bolt. 16 Nm
Removal
Remove the rear left underbody trim. Disconnect the air supply lines and ventilation lines, press the release button to do this.
"1" from fuel tank, "3" to fuel tank, "5" to cal. magnetic valve 1 of activated carbon absorber "N80". Unscrew bolts "2, 4, 6" and remove activated carbon absorber.
Installation
Installation in reverse order: push the ventilation lines until they click into place. Install the rear left underbody trim.
The original version is on the portal: audimanual