Table of contents: Removal the gas pedal module with… ↓ Installation ↓
Gas pedal 1. Accelerator pedal unit. Accelerator pedal position sensor "G79" and accelerator pedal position sensor 2 "G185". On vehicles with dual-clutch transmission or automatic transmission, perform "Kick-down mode adaptation" after replacement; 2. Pedal support; 3. Bolt 8 Nm; 4. Electrical connector
Removal the gas pedal module with the gas pedal position sensor "G79" / "G185"
Remove the lower instrument panel trim on the driver's side. Disconnect the plug connector "2" by pressing the lock "1" upwards "arrow". Unscrew the bolt "3" and remove the gas pedal module downwards.
Installation
Installation is in reverse order, in this case it is necessary to install the gas pedal module "4" from below on the pedal support "1", insert the centering pin "2" and tighten the bolt "3". Install the lower trim of the instrument panel on the driver's side. On cars with a dual-clutch transmission or automatic transmission, after replacement, carry out "adaptation of the Kick-down mode" in "Guided functions".
