Accelerator pedal — design description (Audi A2)

Accelerator pedal:
1. Accelerator pedal stop
2. Accelerator pedal unit with accelerator pedal position sensor "G79" and accelerator pedal position sensor 2 "G185"
3. Electrical connector
4/5. Bolt, 10 Nm

(The original version is on the portal «Audimanual.ru»)

The article was checked by auto expert Daniil Ushakov

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Audi A2: Supply system

Removal and installation the fuel changeover valve
Removal and installation the fuel filter (since 05.2002)
Fuel filter (since 05.2002) — design description
Removal and installation the fuel filter (before 04.2002)

Removal and installation the gas pedal module with position…
Adjusting the gas pedal stop
Checking the pre-heating system

Similar articles on other Audi car models:
Accelerator pedal — removal and installation Audi 80 B3 (1986-1991, petrol)
Heater — design description Audi 100 C3 (1982-1990, petrol)
Ignition system — general description Audi A3 Type 8L (1996-2003)
Engine lubrication system — design description Audi A4 B6 (2000-2006, petrol)
Accelerator cable and accelerator pedal components Audi A6 C4 (1994-1997)
Accelerator cable Audi A8 D2 (1994-2002)
Accelerator Pedal Position Sensor, Accelerator Pedal Position… Audi Q5 Type 8R (2008-2017)

Link to this page in different formats

HTMLTextBB Code

Visitor comments

No comments yet

Audi A2(1999-2005)