3.0. Front wheel disc brake with FNR-G60 caliper:
1 - brake pads. The wear sensor wire is attached to the inner shoe
2 - brake shoe guide
3 - M14x1.5x38 bolts for fastening the guide with a ribbed washer. Tightening torque 200 Nm
4 - guide pin bushings. Installed in holes on the caliper
5 - guide pins. Tightening torque 30 Nm
6 - guide pin caps
7 - brake disc. Apply G0S2142A2 grease to the contact surfaces of the brake disc and hub
8 - wheeled bot. Tightening torque 120 Nm
9 - brake hose fitting. Tightening torque 15 Nm
10 - brake pipeline
11 - fitting of the brake pipeline connected to the caliper. Tightening torque 17 Nm
12- brake hose holder
13 - M8x16 bolt with a hexagonal head for mounting the holder. Tightening torque 25 Nm
14 - support
15 - clamping spring. The ends of the spring are put on the studs of the caliper and the outer brake shoe. After installing the spring on the studs, it should be brought under the ledge of the caliper
Visitor comments