Front door
1. Door: remove the door trim.
2. Bolt: 25 Nm.
3. Door opening limiter.
4. Cover: Place on the mounting pin.
5. Mounting pin: 30 Nm.
6. Upper door hinge.
7. Bolt: 32 Nm.
8. Bolt: 45 Nm. The bolt is a so-called centering bolt, so adjusting the door with this bolt is usually not required. If adjustment is required with these bolts, they can be replaced with 1 of the same length and strength
9. Bolt: 32 Nm.
10. Lower door hinge.
Removal
Disconnect the plug connector to the A-pillar. Unscrew bolt "2" of the door opening limiter. Remove caps "1" and "3" from the mounting pins. Unscrew the mounting pins "4" from the upper and lower hinges. Carefully lift the door up and remove it from the door hinges.
Once the door is installed, no adjustment is required.