2. Disconnect the six-pin connector 3.
3. Remove screws 2 and 4 (only three screws) and remove the accelerator pedal module. In case of replacement, two pedal position sensors G79 and G185 can be taken from the module.
Electronic throttle control with accelerator pedal module: 1 - accelerator pedal module with sensors G79 and G185, 2 and 4 - screws (10 Nm), 3 - six-pin connector.
4. When installing in the reverse order, it is necessary to maintain a tightening torque of 10 Nm for the screws.
[A link to the original source is available on the website AudiManual]