Removal the Throttle Control Module (Audi Q5-8R)

Table of contents: Removal the Throttle Control Module… ↓ Installation ↓

Removal the Throttle Control Module "J338"

Remove the engine casing. Loosen the hose clamp "arrow" and remove the air duct hose downwards.

Disconnect the electrical plug connection "2". Unscrew the bolt "1" of the oil dipstick guide tube. Unscrew the bolts "arrows" and remove the throttle control module "J338".

Installation

Installation is in reverse order, note the following: Replace the O-ring.

The article was checked by auto expert Timur Bazhenov

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Audi Q Q5 Type 8R: Diesel 2.0 liter (CG/CJ/CM)

Intake manifold parts and components
Parts and units of the fuel system (general diagram)
Injection system
Turbocharger — removal, installation

Removal the intake manifold
Parts and units of high pressure pump
Injection nozzles
Removal injectors

Similar articles on other Audi car models:
Control lamps Audi 80 B3 (1986-1991, petrol)
Multipoint injection control unit, knock sensors, throttle… Audi 100 C4 (1990-1994, petrol)
Control unit for Motronic, throttle control unit Audi A3 Type 8L (1996-2003)
Throttle control repair Audi A4 B6 (2000-2006, petrol)
Electrical diagram of the Motronic control unit, knock sensors,… Audi A6 C5 (1997-2004)
Air Conditioning Control Audi A8 D2 (1994-2002)
Connection plan for the boost pressure control system Audi A2 (1999-2005)

Link to this page in different formats

HTMLTextBB Code

Visitor comments

No comments yet

Q7 4L(2005-2015, diesel)

Q5 8R(2008-2017)