Removal the intake manifold (Audi Q5-8R)

Risk of malfunction due to contamination. Remove the engine casing. Disconnect the electrical plug connections of the glow plugs. Unscrew bolt "2" and union nuts "1 and 3", remove the high-pressure line.



Disconnect the electrical plug connections "2 and 3". Unscrew the bolt "arrow" and push the wire holder aside. "Pos. 1" is not taken into account.



Unscrew bolts "1 and 3". Remove fuel hoses by loosening hose clamps "2, 4".



Unscrew bolt "2" and remove differential pressure sensor "G505". Pull the fuel lines up from the cylinder head cover and push them aside.





Open and remove clamp "1". Ignore "Pos. 2".



Remove the air duct hose by loosening the hose clamp "2". Unscrew the bolt "1" of the oil dipstick guide tube. Disconnect the electrical plug connection "3" of the throttle control unit "J338".



Unscrew the intake manifold "arrow" bolts from the outside to the inside crosswise using the Torx T "T10405" bit.

Installation

Installation in reverse order, note the following: Replace the seals. Tighten the intake manifold bolts from the inside out in a cross pattern. Install the high-pressure line.

The original article is available on the online resource: AUDIMANUAL.ru