1. If provided, the filter is installed under the panels near the windshield, on "right-hand drive" models - on the left and on "left hand drive" models on the right.
2. Turn on the wipers, turn on the ignition and turn off the ignition to stop the wiper blades in the middle position.
3. Remove the fasteners of the panels at the windshield by turning them as needed (pic. 22.3).
4. Remove the rubber seal from the corresponding end of the motor shield (pic. 22.4).
5. Remove the filter from the housing (pic. 22.5).
6. Wipe the filter housing unclean and install a new filter. Attach the filter and install the cover. The new filter is set by the label "OBEN" up.
7. The rest of the procedure is the reverse of removal.
Visitor comments