Wiper blades
1. See Weekly checks.
Wiper arms
2. If the drivers are not set to their original position, turn on the ignition and allow the wiper motor to do so.
3. Before removing the leash, mark its position on the windshield by gluing a strip of tape along the brush. Open the cover and unscrew the fastening nut. Remove the washer and pull the driver off the spindle by rocking it slightly from side to side.
4. Installation - reverse procedure. Before tightening the nut to the prescribed torque, orient the driver according to the glued tape strip.
Wiper drive motor
Withdrawal
5. Disconnect the wire "masses" from the battery.
6. Remove the leashes as described above.
7. Detach both sections of the water deflector panel at the windshield and remove it from the motor shield.
8. Turn away bolts of fastening and take out knot of a drive of a screen wiper, having disconnected a wiring connector as becomes available. Remove the bushing installed in the central support.
9. To remove the motor from the rod, carefully unhook the rod from the hinge on the motor, unscrew the three mounting bolts and remove the motor.
Installation
10. Installation - reverse procedure. Tighten the fastening bolts to the prescribed torques. Attach the water deflector carefully.
Visitor comments