1 - gear shift lever handle
2 - case
3 - bolt
4 - retaining ring
Do not overtighten when installing
5 - spacer sleeve
6 - spring
7 - ball stop
Insert the spring and bushing into the ball stop and install it on the shift lever. Position the spring and bushings on the right in the direction of travel. Install the ball stop before installing the retaining ring "15".
8 - spring
9 - bushing
The rounding is facing the shift lever
10 - gear shift lever
Can be installed on the body only in one position
11 - nut, 25 Nm
12 - spring plate
13 - fastening element
14 - tube
15 - retaining ring
Remove before removing the ball joint. Always replace the ring; the rounded side faces the body.
16 - gearshift control mechanism housing
Insert so that the reverse latch is on the left. The ball stop limitation on the right and left must be installed.
17 - support of the switching control mechanism
Seal the bottom with AKD 512001 paste.
18 - nut, 10 Nm
19 - bolt
20 - shift fork
21 - washer
22 - bolt, 10 Nm
23 - cuff
Inserted into the mechanism support and the shift fork
24 - shift rod with hinge 5-cylinder engine; the switching joint is marked in blue
25 - clamping element
26 - bolt, 25 Nm
27 - bolt, 20 Nm
Self-locking, always replace.
Adjusting the switching
Place the car on jack stands.
Remove the lower engine compartment trim.
Place the gear shift lever in neutral position.
Unscrew the lever handle.
Remove the shift lever cover.
Loosen the gear shift rod from underneath the vehicle.
Place the gear shift lever vertically.
Adjust the shift lever so that the distance "a" between the noses of the ball stop and the ball stop housing is the same on both sides.
Tighten the gearbox linkage mounting bolt.
Note: Do not change the position of the lever.
Check if the gearshift lever is in neutral position in the third and fourth gear slot.
Check the switching of all speeds. Pay special attention to the reverse gear lock. If necessary, unscrew the bolts securing the ball joint housing and turn the housing slightly.
Install the shift lever cover. Install the shift lever handle.
Install the lower engine compartment trim.
Remove the car from the jackstand.
[The original publication in its entirety is posted on the website AudiManual.ru]