Table of contents: Autonomous heater and fan ↓ Replacing batteries ↓ Transmitter indicator light ↓ Distance to the car ↓ Heated seats ↓ Comfortable automatic air… ↓ Heated seats ↓ Seat heating/ventilation ↓
The following overview of the climate control controls will help you quickly master the principles of their operation. The air conditioner functions are adjusted by turning the knob or turned on and off by pressing the keys. When a function is turned on, the LED in the corresponding key lights up.
Note: Do not cover or tape the grille located near the controls. There are measuring sensors behind the grille.
(1) The controller also adjusts the fan speed, air distribution and seat heating.
Air Conditioning Controls
Button/Purpose
Turning on and off
Automatic mode
Regulator¹ /Temperature adjustment
Fan
Recirculation mode
Air distribution
Defrosting glass
Rear window heating
Autonomous heater and fan
The independent heater/fan can be switched on/off via remote radio control.
Remote control for autonomous heater
Replacing the battery in the remote control
Turning on
To activate the independent heater/fan, hold down button "1" for approximately 2 seconds.
Shutdown
To turn off the independent heater/fan, hold down the OFF "2" button for approximately 2 seconds.
Replacing batteries
Slide the battery cover back on the radio remote control. Replace the battery. The compartment is marked for correct battery installation. The replacement battery must match the specifications of the original battery. Close the battery cover. The operating time of the independent heater/fan after quick activation is determined by the setting in the menu. The maximum activation time is 60 minutes. If the independent heater/fan needs to be reactivated after the end of its activation time, press button "1".
Transmitter indicator light
The positive result of the execution of the radio remote control command can be verified by the color and rhythm of the flashing of the transmitter indicator lamp "3". If the switch is successfully turned on with the "1" button, the indicator lamp flashes green for approximately 30 seconds. If the switch is successfully turned off with the OFF button "2", the indicator lamp flashes red. If the radio remote control is out of range of the transmitter, the indicator lamp flashes red. If there is a fault in the system (for example, the fuel level in the tank has reached the reserve field), the control lamp flashes red rapidly. In both cases, the signal transmission command is not executed. If the battery of the radio remote control is almost completely discharged, the control lamp of the transmitter does not light and commands cannot be executed.
Distance to the car
The range of the radio remote control is approximately 600 m. However, the range may be significantly reduced due to obstacles located between the radio remote control transmitter and the vehicle (for example, buildings). When transmitting a radio signal, antenna "4" must be directed upwards. The distance to the car must be more than 3 meters. If the distance is less than 3 meters, or if the remote radio control is used inside the car, overmodulation may occur.
Heated seats
Climate control: seat heating button and regulator
Comfortable automatic air conditioner "3 zones"
The following overview of the air conditioning controls will help you quickly learn how they work. The display on the left shows the set temperature for the driver's side, and the display on the right shows the set temperature for the front passenger side. The air conditioning functions are adjusted by turning the knob or turned on and off by pressing the keys. When a function is on, the LED in the corresponding key lights up.
Note: Do not cover or tape the grille located near the controls. There are measuring sensors behind the grille.
(1) The controller also adjusts the fan speed, air distribution and seat heating/ventilation.
Comfortable automatic air conditioner "3 zones"
Button/Purpose
Turning on and off
Automatic mode
Regulator¹/ Temperature control
Fan
Recirculation mode
Air distribution
Defrosting glass
Rear window heating
Turning the cooling system on/off
Seat heating/seat ventilation
Comfortable automatic air conditioner "3 zones": seat heating/ventilation button and regulator
There is a possibility of electric heating and ventilation of the cushions and backrests of the front seats.
Heated seats
Press the key
Turn the regulator to set the desired air distribution mode.
Seat heating/ventilation
Press the button
Seat heating is adjusted by turning the knob clockwise. The red LED in the button lights up. Seat ventilation is adjusted by turning the knob counterclockwise. The blue LED in the button lights up.
In position 0, seat heating and ventilation are switched off. The adjustment range is from 1 to 6. Seat heating only operates if body weight is applied to the seats. To avoid unintentional heating of the front seats, it must be switched off if there are no passengers in front.
[Information obtained from this resource «AUDIMANUAL»]