D-pillar trim 1. Spacer clamp; 2. Speaker cover; 3. D-pillar trim; 4. Spacer clamp; 5. Clamp. 3 pcs. Insert into the casing. Replace if damaged or deformed
Removal
Remove the trunk side trim. Removing the rear roof panel trim. Remove clamps -1- and -3-. Press out the D-pillar trim - pos. 2-wedge -80-200- from the body -arrows- and remove.
Set option with speaker: disconnect el. connector
Installation
Installation in reverse order: if the trim clips are still in the attachment points on the body, remove them and push them onto the trim for installation. Check the clamp clamps for defects and deformations and replace if necessary. Install the D-pillar trim and press until it clicks. Slide the trunk seal along the edge of the upholstery.
Visitor comments