Footrest and floor covering 1. Driver's side dashboard trim; 2. Clamp. Insert into the footrest; 3. Footrest. It is impossible to remove it without damaging it; 4. Front threshold trim; 5. Floor covering. Solid
Removal
When dismantling, the footrest is destroyed and must be replaced. Remove the front panel trim on the driver's side. Remove the front door sill trim on the driver's side. Unfasten the footrest "1" using the wedge "3409" "arrow" and remove.
Installation
Installation in reverse order: replace the footrest and ensure that the footrest is fully secured in the mountings.
Removal the floor covering
Remove the front seats. Remove the rear seat. Remove the dashboard trim on the driver's side. Remove the center console. Remove the center console bracket and lower the gearbox control lever. Remove the air duct from the rear of the center tunnel that goes to the deflector in the center console. Remove the front door sill trims. Remove the lower B-pillar trims. Remove the rear door sill trims. Unfasten the floor covering from brackets "1" and "2". Pull the floor covering "3" to the rear.
Make sure that the floor covering does not tear in the slots. Roll the floor covering lengthwise and remove it from the passenger compartment through the door.
Installation
Roll up the floor covering lengthwise and place it in the car interior. First move the floor covering forward so that the pattern of the air duct holes and the gearbox control lever match. Hang the floor covering on brackets "1" and "2". Install in the reverse order.