Table of contents: Mechanical mirror ↓ Automatic anti-glare mirror ↓
Mechanical mirror
1. Press the mirror leg down and detach the mirror from the support.
2. To install, set the mirror leg at an angle of 60...90° to the vertical and turn it clockwise until the spring snaps into place.
3. If the mirror support comes off, clean the glass of the old adhesive, apply new adhesive according to the manufacturer's recommendations and glue the support back in place. When the mirror is installed correctly on the support, the mirror foot should be vertical.
Automatic anti-glare mirror
4. Unclip the trim from the mirror base/wire guide.
5. Release the wiring from the fasteners and disconnect the connector.
6. Press the mirror foot down at an angle to release the mirror from the support.
7. To install, set the mirror leg at an angle of 60...90° to the vertical and turn it clockwise until the spring snaps into place. Do not hold the mirror by the leg to avoid breaking it.
8. Connect the wiring, its connector and install the leg cover.
9. To check the operation of the mirror, close the photoreceiver at the bottom edge until the mirror brightens, then open the photoreceiver - the mirror should quickly darken, reducing its reflectivity.
This article was previously published on the resource AUDIMANUAL.RU