1. Remove the horn button from the center of the steering wheel, first releasing the top and then the bottom of the button (photo). Do this carefully, otherwise the plastic grips may be broken.
2. Disconnect the horn wiring, remove the block.
3. Set the front wheels straight, place the turn signal lever in the 'neutral' position.
4. Mark the position of the steering wheel and the inner column relative to each other, then unscrew and remove the lock nut and washer (photo).
5. Remove the steering wheel from the inner grooves of the column (photo). If it is tight, pull it slightly while rocking it from side to side.
6. Installation is carried out in the reverse order. Align the pre-made marks, tighten the lock nut with a tightening torque regulated specification. Make sure the turn signal lever is in the 'neutral' position, otherwise the switch lever may be damaged.
Visitor comments