Automatic transmission selector handle, automatic transmission selector position indicator panel "Y26" 1. Clamp: for fastening the handle to the automatic transmission selector; replace; 2. Decorative rosette; 3. Selector handle; 4. Selector cuff; 5. Gear selector position indicator panel "Y26"
Removal
Pull the parking brake lever to engage the electromechanical parking brake. Shift the selector to position "N". The automatic transmission selector handle is removed together with the selector sleeve. Carefully press the selector lever sleeve from the side using wedge "3409" "arrows" and twist it upwards.
Provide the cable connector with the locking button in the extended "arrow" position as shown in the figure.
Place the gearshift lever sleeve "1" on top of the gearshift handle "2". Disconnect the clamp "arrow" and remove the selector handle together with the selector sleeve, without pressing the locking button.
Installation
To install the automatic transmission selector handle, the locking button must be pulled out as far as it will go and secured with the "arrow" cable tie or the mounting device supplied with the new handle. If the locking button was not secured due to an oversight, it must not be removed from the automatic transmission selector handle using a mechanical auxiliary tool. Place a compressed air gun against the handle from below and press out the locking button with compressed air. Place a new "arrow" clamp on the selector handle. Place the automatic transmission selector handle completely on the selector - the locking button faces the driver. In this case, the handle must enter the annular groove of the automatic transmission selector. Remove the cable tie or mounting device, while the locking button drive enters the vertical groove of the selector. If necessary, press the locking button into the selector handle. To check the operation of the button mechanism, move the selector to the "R" and "S" positions. If the selector cannot be moved to the specified positions, the handle must be removed again. Secure the automatic transmission selector handle "2" with the "arrow" clamp on the automatic transmission selector, for this use pliers for hose clamps "V.A.G 1275". Secure the automatic transmission selector cuff retainer frame "1" to the center console.
Separating the automatic transmission selector cuff from the selector handle
Remove the automatic transmission lever handle. Tie the spring tabs "1" of the selector handle with a cable tie "3", as shown in the figure. Slide the sleeve "2" of the selector cuff through the spring tab latches "arrow". Remove the cable tie and remove the sleeve with the cuff from the selector.
Installation
Installation is in reverse order. The longer side of the automatic transmission selector sleeve frame faces the driver. Install the automatic transmission lever handle.