Removal and installation the automatic transmission selector push rod (Audi A2)

Table of contents: Removal ↓ Installation ↓

Removal

Disconnect the retainer «1» from the pin «arrow» upwards. Press the push rod «2» to the spring «3»…

Disconnect the retainer "1" from the pin "arrow" upwards. Press the push rod "2" to the spring "3" and remove the pin.

Installation

Installation in reverse order.

The article was checked by auto expert Daniil Ushakov

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Previous articles

Audi A2: Mechanical gearbox 085 DS

Next articles

Disassembly and assembly of the gearshift mechanism drive
Removal and installation the gearshift mechanism drive
Gear shift mechanism drive — design description
Removal and installation the fastener and insert with symbols

Removal and installation the selector potentiometer
Removal and installation the N110 automatic transmission…
Gear shift unit — design description
Removal and installation the gear shift unit

Similar articles on other Audi car models:
Vacuum Pump (with Automatic Transmission) — Removal and… Audi 80 B3 (1986-1991, petrol)
Automatic transmission selector Audi 100 C3 (1982-1990, petrol)
Adjusting the Automatic Transmission Shift Selector Cable Audi A3 Type 8L (1996-2003)
Automatic transmission gear selector positions Audi A4 B6 (2000-2006, petrol)
Automatic transmission Audi A6 C5 (1997-2004)
Automatic transmission selector Audi A8 D2 (1994-2002)
Automatic transmission selector handle, automatic transmission… Audi Q5 Type 8R (2008-2017)

Link to this page in different formats

HTMLTextBB Code

Visitor comments

No comments yet

Audi A2(1999-2005)

This site uses cookies 🍪. Click the button to accept this fact.