Table of contents: Removal ↓ Installation ↓
Removal
Remove the gear shift mechanism drive.
Disconnect connectors "1" and "2" and release the electrical wires.
Unlock the fastening on both sides of the "arrow" and remove it.
Disconnect connector "1" from the mount. Disconnect electrical connectors "2" and "5". Cut cable tie "3" and remove cable clamp "4". Unscrew the "arrow" bolts, remove the gearshift mechanism drive from the housing.
Raise the locking lug "1" at the stopper, moving the locking clamp "2" until it stops "in the direction of the arrow".
Unscrew bolts "1" and remove the automatic transmission selector lock solenoid "NII0" pos. "2".
Installation
Installation is in reverse order, taking into account the following: install and tighten the automatic transmission selector lock solenoid "N110".
Press the automatic transmission selector lock solenoid "N110" away from the stopper "3" by moving the locking clamp "2" in the direction of the "arrow" until the locking lug is locked. Make sure that the automatic transmission selector lock solenoid is connected to the stopper. Install the mount and insert with symbols. Install the gearshift mechanism drive. Install the center console. Pay attention to the battery installation work. Check the gearshift mechanism drive. Check the ignition key removal lock mechanism. Perform basic settings in the "Vehicle self-diagnosis" mode.
[The original text is available on the website: audimanual.ru]