Table of contents: Removal ↓ Installation ↓
Removal
Remove the front side trim. Remove the door sill trim 1 (fig. 12.85) three clamping lugs. Disconnect the threshold trim with the holder 5 (fig. 12.85) from the lower trim of the 2 middle pillars.
Fig. 12.85. Threshold trim
1 - threshold trim,
2 - lower trim,
3 - holder,
4 - holder,
5 - holder.
Disconnect the two lower clips of the door sill trim.
First, detach the holder 4 from the lower trim of the middle pillar (fig. 12.85), then holder 3.
Installation
If the switch is removed, insert it in the reverse order into the trim and secure it.
Connect the electrical connector to the pushbutton switch.
Replace the upholstery by sliding it downwards until it snaps into place, making sure that the seat belt guide 2 (fig. 12.89) entered the holder 7, and the guide pins 3 and locking protrusions 4 entered the holes 5 and 6.
Install the door sill trim.
Install the upper B-pillar trim.
Place the door seal on the left and right sides above the trim.
The original article is available on the online resource AUDImanual.ru