Loosen the bolts on the door frame enough to allow the door frame or adjuster plate to move.
To adjust the position of the door frame, you need to have an assistant in the car.
Close the door.
From the inside, an assistant should press the door frame against the roof and A-pillar.
From the outside, check the position of the door frame 1 (fig. 12.35) in the door frame. Sealing chamfer 2 (fig. 12.35) should fit snugly against the front pillar and roof frame (arrow fig. 12.35).
From the inside, the assistant presses the door frame towards the middle of the car. The pressure on the door frame should be slightly greater to compensate for the elastic force of the rubber seal.
Move the adjustment plate 7 (fig. 12.29) relative to the B-pillar.
Carefully close the door and tighten the bolts in the following sequence: 3, 9, 6, 4 (fig. 12.29).
If the adjustment area of the plate is not sufficient, a thicker washer must be placed under it. Never use two plates in one place.