Table of contents: Removal ↓ Installation ↓
Removal
Remove the trunk lid trim. Disconnect the operating rod 4 (fig. 12.28) from the handle control.
Fig. 12.28. Trunk lid lock
1 - lock,
2 - articulated lever,
After installing the lock, move it to the working rod.
3 - nut, 8 Nm,
4 - working thrust,
Adjust so that the working rod moves freely and without tension.
5 - nut, 8 Nm,
6 - handle control,
7 - servo element,
8 - locking cylinder,
9 - Remote release motor.
For removal, the working rod 4 must not be removed from the articulated lever.
10 - bolt, 1.2 Nm,
11 - working thrust
Note: The figure shows the boot lid lock of the AVANT. Removal and installation of the lock in Limousine cars is similar.
Unscrew nuts 5 (fig. 12.28) and remove the handle control.
Remove the hinge arm 2 (fig. 12.28) from the working rod 4 and remove it from the lock.
Unscrew nuts 3 (fig. 12.28) and remove the lock.
Installation
Installation is carried out in the reverse order of removal.
Note: The trunk lid lock has two latching positions. When the operating control rod is adjusted correctly, the trunk lid lock should latch into the second (main) position.
(The original publication in its entirety is posted on the website AUDIMANUAL.RU)