Removal and installation, adjustment of the trunk lid and trunk lid lock (Audi A2)

1. Trunk lid. Remove the trunk lid trim. Disconnect the plug connectors and remove them from the lid. Remove the gas struts from the lid side. Unscrew the Torx bolts and remove the lid
2. Buffer. There are markings on the trunk lid that allow you to adjust the buffer. When installing, lightly secure the buffer. Close the lid and bring it to a level position. Open the lid and remove the buffer by one division of the scale. Tighten the bolts to 8 Nm
3. Bolt Tough, 8 Nm
4. Hexagon nut, 23 Nm
5. Trunk lid lock. To remove, disconnect the lock drive rod, unscrew the nuts and remove the trunk lid lock
6. Hexagon nut, 15 Nm. Accessible in the area of the headlining only after dismantling
7. Bolt Tough, 15 Nm
8. Trunk lid hinge. Bend the headliner next to the hex nut and unscrew the nut. Unscrew the hex bolts
9. Hexagon head bolt, 15 Nm
10. Ball joint, 10 Nm
11. Gas strut. Support the cover. Using a small screwdriver, lift the locking bracket from the top and bottom, remove the gas strut from the ball joint. To install, simply press it into the ball joint. Hang the gas strut pipe from the body side
12. Ball joint, 10 Nm