7.0. Rear wheel brake with C43 caliper:
1 - caliper mounting bolts. Tightening torque 35 Nm. The bolts are self-locking and therefore must be replaced at every disassembly. When unscrewing and tightening the bolt, the guide pin should be kept from turning with a wrench
2 - support
3 - brake pads. It is mandatory to change all four pads at the same time
4 - shoe holders. To be replaced when installing new pads
5 - brake disc. Lubricant G052142A2 should be applied to the contact surfaces of the disc and hub
6 - hexagon socket head bolts for fastening the brake shoe guide. The tightening torque depends on the size of the bolt. Bolts M10x60 and M10x1.25x50 are tightened with a force of 70 Nm + 90°additional turn. Bolts M10x1.0x20 are tightened with a force of 95 Nm
7 - brake shoe guide with guide pins and their caps. Supplied complete with grease for guide pins. If the protective caps of the fingers are damaged, a new guide from the repair kit should be installed, and the fingers should be lubricated
8 - hollow bolt for fastening the brake hose. Tightening torque 40 Nm
9 - brake hose
10 - brake hose seals
Visitor comments