Withdrawal
1. Remove the timing belt.
Tensioner
2. Turn the tensioner pulley counterclockwise and insert the pin into the hole located at the top of the pulley. Remove the bolt from the hub. Unscrew the tensioner mounting bolts.
3. On AAE, ABK, AAD engines, unscrew the bolt and disconnect the tensioner from the front of the engine, twist the nut and disconnect the tensioner pulley.
4. On ACE engines, unscrew the nut and disconnect the hub at the front of the engine.
Camshaft sprocket
5. Stop the sprocket and unscrew the bolt.
6. Take out the bolt.
7. Take out the segment key.
Intermediate shaft sprocket
8. Unscrew the sprocket bolt and remove it.
Crankshaft sprocket
9. Unscrew the sprocket bolt, having previously locked the shaft, and remove the sprocket.
Examination
1. Clean the sprockets and check them for wear and damage.
2. Check the tensioner for wear and damage.
Installation
Crankshaft sprocket
1. Slide the sprocket onto the shaft and tighten the bolt.
2. Install the timing belt.
Intermediate shaft sprocket
3. Insert the key into the shaft, put on the sprocket and tighten the bolt.
4. Put a belt on the sprocket.
Camshaft sprocket
5. Insert the key, put on the sprocket, washer and tighten the bolt.
6. Put a belt on the sprocket.
Tensioner
7. Install tensioner.
Visitor comments