Withdrawal
1. Remove the rear wheel.
2. Remove the cap from the center of the brake drum.
3. Remove the pin and lock cap.
4. Unscrew the hub nut, remove the washer and the outer bearing.
5. Remove the brake drum. If the brake pads prevent the removal of the brake drum, perform the following operations.
6. Loosen the handbrake cable.
7. Using a screwdriver, lift the wedge (arrow), to move the pads away from the drum.
Inspection
Clean the brake drum and inspect it for damage or wear. Measure the inner diameter of the drum at several points. Repair or replace the brake drum if necessary.
Installation
Installation is carried out in the reverse order of removal.
Visitor comments