Roof spoiler replacement
In addition to adhesive tape, the spoiler must be glued using additional adhesive. glue roller. The spoiler may only be installed using mounting hardware. glue -D 172 090 A2-.
1. Roof spoiler: heat the cover in the area of the adhesive joint using the "VAG 1416" hair dryer, remove the spoiler from the cover gradually, starting from the side, completely remove the remaining adhesive from the adhesive tape from the cover, cut off the remainder of the adhesive roller from the cover between the adhesive tapes, before installing the new spoiler, clean the surface of the adhesive joint with the cleaner -D 009 401 04-, wipe the cleaned surface with a paper napkin, apply glue between the rear adhesive tapes over the entire width of the spoiler. The adhesive surface of the spoiler and cover must be free of dust and oil. When dismantling, cover the adjacent painted surface of the cover with textile-based adhesive tape.
2. Trunk lid.
3. Double-sided adhesive tape: Remove the paper protection immediately before installation.
4. Glue roller: mounting adhesive -D 172 090 A2-, apply a 3 mm diameter glue roller, cut off the nozzle at the appropriate place.
Applying a spoiler
1. Trunk spoiler.
2. Double-sided adhesive tape: included; remove paper protection immediately before installation.
3. Glue roller: cut the nozzle so that the inner diameter is 3 mm, apply the glue from the delivery set between the adhesive tapes with a diameter of 3 mm over the entire width of the spoiler, install the spoiler, sliding it forward until it stops, in the center of the cover; gradually press the spoiler with force, starting from the middle and then to the sides, fix the spoiler with adhesive tape for the curing period. The car with the spoiler installed must remain at room temperature for at least 4 hours.
4. Trunk lid.
5. Rear window.
Lower rear spoiler
Unscrew nuts "2" and remove spoiler "1" from spare wheel niche "3".
Spoiler per. wheels
1. Wheel spoiler: unscrew the fender liner bolts in the spoiler area, push the fender liner in the spoiler area to the side and unscrew the clamping pins, remove the wheel spoiler under the fender liner.
2. Clamping pin.
3. Fender liner.
4. Bolt: 1.5 Nm.
5. Noise insulation screen, front.
6. Bracket: place on the sound insulation.