2. Raise and position the vehicle on the platform.
3. Unscrew the oil filler plug, depending on the version, using a 10 mm socket wrench, for example, HAZET 985-10, or a socket wrench with a polyhedron, for example, AUDI-3357 or HAZET 2567-16. The plug is located on the left side of the gearbox under the speed sensor and can be covered by the heat shield of the drive shaft.
4. Check the oil level with a wire bent at an angle. The oil level should be 7 mm below the lower edge of the oil filler hole.
Warning: Filling up to the lower edge of the hole is also allowed. Use only synthetic oil specified in Specifications.
5. Tighten the plug to the specified torque 25 Nm.
Warning: The plug is different for gearboxes made of aluminum and magnesium alloys.