Table of contents: Removal ↓ Installation ↓
Removal
1. Auto-dimming mirror: Remove the cover (3), remove the plug from the holder and disconnect it.
Caution: Do not rotate the cable channel (2).
2. Turn the mirror (1) by 60 to 90° counterclockwise (arrow B) so that the locking spring is released.
3. Remove the mirror back (arrow A).
Installation
1. Install the mirror by rotating it at an angle of 60 to 90° and then rotate it clockwise until the locking spring is locked.
2. Auto-dimming mirror: Connect the connector and secure it in the holder. Replace the cover (3).
3. Auto-dimming mirror: Check the operation of the mirror. To do this, turn on the ignition, cover the photosensor from the front of the mirror and illuminate the photosensor from the back of the mirror with a pocket flashlight. The mirror should darken within a short time.