Table of contents: Removal ↓ Installation ↓
Removal
Remove the trim under the front panel.
Remove the center console.
Remove the heater control knobs.
Unscrew one bolt and remove the cover.
Remove four bolts and carefully remove the heater control panel.
Release the clamp with a screwdriver and pull the cable to the heater control panel.
Disconnect the cable from the corresponding valve and pull it out
Installation
A damaged or rubbing cable must be replaced.
Connect the cable, snap the clamp. The picture shows the fastening on the temperature, central or footwell flap.
Attention: If the hooks break, secure the cable with screws.
Install the middle part of the control panel.
Install a glove compartment box.
Install the middle console.
Install the cladding.
[A link to the original source is available on the website: AUDImanual]