Withdrawal
Open the hood.
Disconnect the hose from the nozzle.
Press the nozzle tip in the direction of the arrow and pull the nozzle upwards.
Installation
Insert the nozzle from above and push back until it clicks.
Put on the hose.
Adjustment
The direction of the jet can be set using a wire with a diameter of 0.8 mm. Do not use needles.
Dimensions of the jet direction adjustment layer: a 200 mm, b = 450 mm, c = 480 mm.
The jet can be cleaned with compressed air
Rear glass (coupe)
Dimensions for jet direction adjustment: a = 300 mm, b = 550 mm
The jet can be cleaned with compressed air.
Visitor comments